Mitsubishi Outlander Won't Start: Common Causes and Checks (Australia)
The usual reasons an Outlander won't start, from the 12V battery and the key to the starter and the PHEV READY system, in the order worth checking.
Is this happening to your Mitsubishi Outlander?
Mitsubishi Outlander
ChangeFree preview. No card needed.
The Outlander has been sold here as a petrol, a turbo-diesel and, since 2014, as the PHEV plug-in hybrid, which is the version most Australian buyers know. They're different cars underneath, but their no-start problems overlap far more than you'd expect: a small 12-volt battery, a key that isn't detected, or a starter circuit that won't play ball. The PHEV adds one more thing to understand, because it doesn't crank at all when it's working normally.
If you'd like a ranked list of likely causes for your Outlander and symptoms, the DIY Mechanic app can work through it with you. Start with the checks below.
Why won't my Outlander start?
- Flat or ageing 12V battery: on every version, and by far the most common cause.
- Loose or corroded battery terminals: everything looks dead even with a good battery.
- Flat key fob battery: the car stops detecting the key, so push-button start does nothing.
- Brake pedal not pressed firmly: push-button Outlanders need a solid press before they'll start.
- Gear selector not fully in park: the starter circuit is locked out.
- Starter motor: a bright dash with one heavy click or silence points at the starter or its wiring.
- Immobiliser not accepting the key: usually a security light or a key warning on the dash.
- Diesel-specific faults: a turbo-diesel Outlander can also fail to start from a fuel or glow plug issue.
My Outlander PHEV won't go into READY. What's wrong?
A PHEV doesn't crank, so a no-start usually means the car won't switch into READY mode. The big drive battery is rarely the problem. What goes flat is the small 12-volt auxiliary battery, which runs the computers, relays and locks that wake the hybrid system up. If it's flat, the car won't go into READY no matter how much charge is in the drive battery. You'll typically see a dead dash, dim lights, or a car that unlocks reluctantly.
- The 12V battery lives away from the engine bay, under a cover in the cargo area on the PHEV. The handbook shows exactly where.
- Check the handbook for the correct jump-start points before connecting anything. Don't guess at terminals on a hybrid.
- A PHEV left sitting for weeks, or only ever charged rather than driven, is a classic candidate for a flat 12V battery.
- Dashcams with parking mode and aftermarket trackers are common drains on these cars.
- If it powers up after a jump but won't again the next day, the battery is due for replacement or something is draining it.
Outlander no-start symptoms and what they usually point to
| What you notice | What it usually points to |
|---|---|
| Cranks slowly, dash dims | Battery, terminals or earth strap |
| Single click with bright dash lights | Starter motor or its wiring |
| Nothing at all, no dash lights | Battery or a main fuse |
| PHEV powers up but never reaches READY | Flat 12V auxiliary battery, or a hybrid system fault |
| Start button does nothing, key warning on dash | Fob battery flat or key not detected |
| Cranks fast but won't fire | Fuel supply or immobiliser, not the battery |
What can I check myself?
- Try the spare key, and hold the fob right against the start button if its battery may be low.
- Check the battery terminals for looseness, white crust or a slipping clamp, and check the earth strap where it meets the body.
- Look at the dash lights while cranking. Bright and steady points away from a flat battery; dimming or flickering points straight at it.
- Make sure the car is in park with your foot firmly on the brake.
- Think about what was left on: interior lights, a boot light, a dashcam, an accessory socket. Then charge the battery properly rather than idling the car for ten minutes.
- If your Outlander uses a key rather than a button, try wiggling the key in the barrel while turning: a worn barrel or a dirty reader coil can cause an intermittent no-start.
When should I see a mechanic?
See one if the car needs repeated jump starts, if it cranks but won't fire, if a security, hybrid or engine warning stays on, or if a PHEV refuses to go into READY with a healthy 12V battery. A workshop can test the battery and charging system, check the starter draw and read the fault codes. On a PHEV, go to someone who works on them rather than a general workshop guessing at the hybrid system.
To narrow down the most likely cause for your Outlander before you book it in, start a free diagnosis preview below.
Related guides
Mitsubishi ASX and Eclipse Cross CVT Problems
Why Mitsubishi CVTs shudder, the service bulletin to raise before anyone quotes you for a new gearbox, and the fluid mistake that kills them early.
Read guideMitsubishi Triton DPF Problems? Causes and Fixes (Australia)
What the Mitsubishi Triton's DPF warning light means, why it comes on, and how to clear it with a proper regen before it becomes a bigger problem.
Read guideCar Clicks But Won't Start? What the Clicking Means
The difference between a single clunk and rapid clicking, what each one points to, and the checks you can do in a driveway before you spend a cent.
Read guidePush-Button Start Not Working? Car Won't Start
The backup start procedure almost every keyless car has, why your key suddenly stopped being detected, and how to get going without a tow.
Read guideIs this happening to your Mitsubishi Outlander?
Mitsubishi Outlander
ChangeFree preview. No card needed.
